|
|
Post by Dan MacMillan on Jun 5, 2011 16:20:12 GMT -5
What is the trick to installing the "L" shaped pieces? I am using flat glass "not much different than the curved" and cannot see any way to get it in. I have the manual and followed it but it basically says to install the slider and once the curved H trim is on the bottom of the "L" to install the glass. The H trim causes the glass to be too high and on an angle that will not match up with the slider.
|
|
|
|
Post by Dan MacMillan on Jun 11, 2011 15:57:12 GMT -5
solved
|
|
|
|
Post by buffalobradleygt2 on Jun 11, 2011 21:31:51 GMT -5
What was the cause of the fitting problem ad how di you solve?
|
|
|
|
Post by Dan MacMillan on Jun 14, 2011 9:58:47 GMT -5
The lower window ledge/guide for the sliding window has to be removed. It allows the slider more movement so the H trim can shift out of position. Also when using flat glass, the H trim goes in BEFORE attaching it to the L shaped glass. I had to omit the seal between the L glass and the H channel. A few coats of release agent on the L glass with a bead of silicone in the H channel solved the problem of no seal. The glass is now easily removable.
|
|
