ts
New Member
Posts: 16 
|
Post by ts on Nov 12, 2017 2:49:15 GMT -5
Hi can anyone show here a photo of how the front bumpers are connected in a GT?
I have two steel pipes to hold the bumpers but not sure how to connect them..
Thanks!
|
|
mpm
Junior Member
Member since 2008
Posts: 51
|
Post by mpm on Nov 12, 2017 10:47:28 GMT -5
|
|
mpm
Junior Member
Member since 2008
Posts: 51
|
Post by mpm on Nov 12, 2017 10:50:02 GMT -5
|
|
ts
New Member
Posts: 16
|
Post by ts on Nov 12, 2017 13:03:05 GMT -5
I'm sorry but I am not using facebook.. can you send in another way?
|
|
|
|
Post by peteinms on Nov 12, 2017 13:08:49 GMT -5
Bumper goes into pipe. Hole drilled through both secures pipe to bumper. U- bolts hold the pipe to front torsion tube and a long bolt goes through the forward most outside body mount hole, through a spacer approx 1” long and through the end of the pipe. There also may be another U-bolt to the lower front valance.
At any rate that’s how it was set up on my car. Hope this helps.
|
|
ts
New Member
Posts: 16
|
Post by ts on Nov 13, 2017 2:49:52 GMT -5
Got it and installed to two bumpers.. thank you very much!
|
|
