|
|
Post by larry9j on Jul 5, 2013 14:36:38 GMT -5
Hey Guys,
Can anyone tell me what type of rear window louvers will work on a gtll.
Thanks,
larry9j
|
|
|
|
Post by skip20 on Jul 5, 2013 14:56:20 GMT -5
I haven't found any that fits without cutting them down to size.
|
|
|
|
Post by Wyn on Jul 13, 2013 12:17:37 GMT -5
Larry Today my son gave me an air vent from his VW to use on the brad air vent. I took it to my brad to check for size and will it work, I think so. I also cut off most of the duct so it will fit the outside opening. The opening will need a little enlargement to accept this air duct and needs a little bit of screen to keep bugs from getting into the car. It will be no problem. I will need to use epoxy or RTV to hold the vent in place and paint to match. I'm need to order 2 sets from West Coast Metric for $10.45 a pair. Mid America motorworks also has them but at $19.95 per pair. Wyn www.westcoastmetric.com/viewProduct.php?productID=113-719A-L%2FR&from_search=1   |
|
|
|
Post by Wyn on Jul 13, 2013 12:48:51 GMT -5
The only problem I see is more rain water can get into the air ductwork. Since it is all fiberglass that is no big problem, but will need some holes drilled from under neath at each side of the engine compartment to allow this water to drain.  Wyn |
|
|
|
Post by cocacoladodge on Jul 14, 2013 14:03:24 GMT -5
Problem solver... well for the GT, should work for the GT II also. Profile  Back looking to front  Forgot about this picture, this is what it was like when I bought it  Front looking to back  Low enough that you can't see it from the front ;D  inside looking up and out  Since I'm at it, here is something that KITCARGUY made for me a couple years ago. also have them on my tool boxes and extras for whatever.   |
|
