|
Post by bradley85 on Jun 9, 2013 17:03:02 GMT -5
Do any of you have a recommendation for coil/over shocks for the front of my GTII? I went completely through the front beam, ball joints, tie rods, etc. when I built the car and I just DO NOT want to go through the trouble of installing an adjustable beam. The passenger side tie rod will bump the inside fender well glass if a bump in the road is fairly severe. It has hit hard enough to put a very small bend in the tie rod. Any comments on your ideas or use of coil/overs will be greatly appreciated. Thanks, Greg
|
|
|
Post by Wyn on Jun 9, 2013 20:48:49 GMT -5
Greg, Great looking GT-2. I am using a king pin front and it is also low, but the rear torsion assembley was removed from a dune buggy and the torsion bars are set all the way up, so I'm going to need someone to reset them lower. Wyn Man I love that Blue !
|
|
zaucy
Full Member
Posts: 127
|
Post by zaucy on Jun 9, 2013 21:07:03 GMT -5
|
|
|
Post by bradley85 on Jun 11, 2013 11:32:44 GMT -5
I will try once again to see if I can figure out how to successfully post photos to this site. If I can, I will try to send you some info. Greg
|
|
|
Post by Dan MacMillan on Jun 11, 2013 11:51:48 GMT -5
|
|
|
Post by bradley85 on Jun 12, 2013 12:21:01 GMT -5
Thanks, Will do on the toe. The tie rod is just very slightly bent and the coil/over EMPI shocks brought the front up about 1" at the lowest setting and there is an adjuster that will let me go three step higher if I ever need to. Greg
|
|