|
|
Post by skip20 on Mar 7, 2013 18:07:01 GMT -5
I used some chicken wire to form out walls and next will fit it over the engine to see where else I may need to cut or trim. I figure I should have a good idea what I need space wise before starting to fiberglass it in. Still need to make a few minor adustments. Sorry I didn't see this sooner. Just LOOK at it! There's not a straight line on the whole thing!!!!!!!! |
|
|
|
Post by skip20 on Mar 7, 2013 18:08:36 GMT -5
Have measured out the area I need to open the engine cover, made the cut. Using aluminum flat rods I have made a basic framework moving the cut out away from the cover. SLOOP the top down or you will have a pool to swim in. |
|
