|
|
Post by gitrdun on Jul 19, 2012 20:55:12 GMT -5
I am thinking of adding some vents to the rearend of my GT to let some of that hot air out that builds up under the rear deck. I have a 3d printer so making my own custom vents should be a breeze. Has anyone here tried this before? Wheres the most effective place to put the vents?
|
|
|
|
Post by cocacoladodge on Jul 25, 2012 18:57:28 GMT -5
one idea is just behind the seat on the lower vertical section of the body. don't do the upper part, you have to think about the gas tank... if you have the fastback, and don't mind pulling the glass, youcould cut threw just above the carb and fan shroud, of corse then it would be loud inside, good luck!
|
|
|
|
Post by cocacoladodge on Jul 25, 2012 18:58:17 GMT -5
one idea is just behind the seat on the lower vertical section of the body. don't do the upper part, you have to think about the gas tank... if you have the fastback, and don't mind pulling the glass, youcould cut threw just above the carb and fan shroud, of corse then it would be loud inside
remember, measure twice cut once, and good luck!
|
|
