mandm
New Member
Posts: 5
|
Post by mandm on May 12, 2012 18:55:15 GMT -5
i'm getting ready to install a new front floor support and have read somewhere that the body drifts to one side. i could install the support off to one side to correct this now but i can't find were i read which way the body goes, if anyone remembers i would appreciate a reply. my body appears to need to go to the right, too far left now, but everything is in pieces so it is hard to get a good measurement
gt 1
thanks
|
|
|
|
Post by cocacoladodge on May 15, 2012 17:12:48 GMT -5
the only suggestion I have is measure how far the tires stick out on each side when they are straight.
|
|
|
|
Post by smyrnaguy on May 15, 2012 18:48:09 GMT -5
The body of the Bradley I'm finishing is offset toward the passenger side almost 1 inch. It is also 1/2 inch longer on the passenger side. I think they used the "that looks close enough, my tape is across the shop" method of deciding where to join the front and rear.
|
|
|
|
Post by gitrdun on May 21, 2012 19:25:20 GMT -5
Mine is off by about 3 or 4 inches to the left. The left front tire is well under the fender and the right front hangs out. Dont know if its fixable now or not.
|
|
Zmud
Junior Member
Posts: 57
|
Post by Zmud on May 21, 2012 21:26:22 GMT -5
|
|
