There are two "Plywood" compartments fiberglassed into each side of my Bradley..Right at the door.One is destroyed by rot and accident damage.Are both side the same sizes from factory?Are these compartments factory?I want to use the passenger side as a template for drivers side.The body panel has moved out due to the missing compartment.I have not seen this discussed on any forum...Need expert opinion.Thanx Dan
Mine were dry rotted but most of it was still there I removed the rear speakers and vacumed out all the partical board chips, all most looked like a rat had been chewing on it. mine was not plywood it was all partical board and you know what happens when that stuff gets wet it all falls apart. I used a few strips of aluiminium flat stock and fiberglassed it in between the floor pan and the outer friberglass fender it gives it lots of extra support. If you are running your heater ducts through the tunnels be sure they are in place first and what I did then was use five cans of expandable spray foam and filled the entire viod areas on bolth sides. Worked great for me sound proofing and insulation all in one step.