|
|
Post by willyknight on Aug 4, 2011 19:51:13 GMT -5
My Bradley is supposedly a 1968 chassis and it has a single resavoir master cylinder so I would feel better if my emergency brake worked.All the parts are gone off the right side and the left side does not work.Is there someone who has the whole kit because as I have stated in another post this is my first VW and I have no clue as to what it was supposed to look like or where it hooks up.The handle is there.
|
|
|
|
Post by jspbtown on Aug 4, 2011 20:05:00 GMT -5
|
|
|
|
Post by willyknight on Aug 4, 2011 20:14:03 GMT -5
Thank you sir.
|
|
|
|
Post by Dan MacMillan on Aug 6, 2011 15:07:31 GMT -5
The pic above is for the left side, You should upgrade to a dual master cyl. Try www.cip1.com they may have what you need or www.thesamba.com classifieds. |
|
|
|
Post by willyknight on Aug 9, 2011 2:27:19 GMT -5
Thanks for the info.The bad part about changing to dual is I just machined a beautiful billet aluminum single resavoir because I did not like the plastic.I was in a hurry to drive it and did not want to take the time to change to dual but wanted it safe and the previous owner had the lines epoxied into the resavoir and epoxied into the master cylinder.I pulled the rubber and plastic out of the master cyl and ran a 3/8 pipe tap in then (after pulling the chips out with a shop vac and then using high pressure air to blow out any residual metal)installed a brass 3/8 to 1/4 adapter and ran steel lines from resavoir to master cyl.There is only about a 3/16 lip at the top of hole to thread on master but it is sufficient since the brass adapter will expand and will not be taken in and out.It feels very secure.
|
|
