|
|
Post by Dan MacMillan on Nov 9, 2011 18:07:52 GMT -5
Just wanted to thank MJ for the stainless hood vent trims. They will come in handy on my Subaru conversion. As the Subaru is liquid cooled and I am hoping to have the rad in the back, they should provide a nice finished look to the air outlets. Time and some experimenting will tell. They may end up in the front as intended. Very well made.
Thanks MJ
|
|
|
|
Post by mj on Nov 13, 2011 18:28:30 GMT -5
Just wanted to thank MJ for the stainless hood vent trims. They will come in handy on my Subaru conversion. As the Subaru is liquid cooled and I am hoping to have the rad in the back, they should provide a nice finished look to the air outlets. Time and some experimenting will tell. They may end up in the front as intended. Very well made. Thanks MJ I am happy that they arrived. Remember that to fit the curve/bend of each vent you have to cut the trim just below the middle hole with a thin Dremel cutting wheel. I fill the difference, if it shows, with solder. Hope it works out for you. I'm now out of those parts. Best, MJ |
|
|
|
Post by Dan MacMillan on Nov 13, 2011 21:55:09 GMT -5
What kind of solder? acid core. resin core. silver.....
|
|
|
|
Post by mwilson on Dec 5, 2011 18:51:38 GMT -5
MJ,
In addition to the hood vents, have you ever thought about doing trunk vents? I know they would be curved which might make it more difficult.
Thanks,
|
|
